PDA

View Full Version : How to remove inner door panel???



tony_mz3
10-29-2007, 09:39 AM
This is not the door panel you removed when you install/replace speakers. this is the inner panel where the speakers mounted on.

There are bolts around this inner panel. I removed them all and still can't take it out.

I try to apply dynamat to the inside metal surface. Couldn't find it in the how-to section. Guess I am the only one here who think about doing this?

blue3
10-30-2007, 07:00 AM
use some elbow grease , mabey there is some sort of silicone holding it down

Cardinal Fang
10-30-2007, 08:02 AM
Here's a great walk through from another board.

http://www.cardomain.com/ride/495957/3

tony_mz3
10-30-2007, 10:58 AM
Here's a great walk through from another board.

http://www.cardomain.com/ride/495957/3

:chuckle
Sorry! you probably didn't read my original post well.

You remove one panel to expose the speaker (this is the link you provided and this is NOT what I am looking for).
You then need to remove the inner panel where the speaker is mounted to get to the bare metal (this is what I am looking for :bana2).

I finally figure it out that removing bolts around the inner panel is not enough. There are 2 bolts to hold glass window covered by small plastic cap. I need to lower window and then remove 2 bolts.

Cardinal Fang
10-30-2007, 12:47 PM
*File this under Fang wasting another person's time*

tony_mz3
10-31-2007, 10:42 AM
:chuckle liar has it all. Remember to do your homework next time then don't need to apologize.

MPS
10-31-2007, 10:47 AM
you dont need to do all that
just dyno the spot @ behind the speaker thats all you need