How to remove floor liners 2014 Mazda3

[TReyes]

Hi all,

Probably a dumb question and I've searched the forums for an answer to no avail...

For people who have purchased the Mazda Floor Liners on 2014 Mazda 3's (or any model), does anyone know how to remove them for cleaning? I've tried pushing down on the buttons but they don't seem to budge. Is this easier than it seems and I'm just clueless?

http://i62.tinypic.com/6gdizt.jpg

Thanks
Tim

[ds08tf]

You have to lift up the middle 'button' part (smaller circle inside the larger circle) . Use a small (jeweler) flat head screwdriver or something plastic if you want to avoid scuffs or even your fingers and try to lift up the 'button' part. One it lifts up a little bit it should come right out .

That's how gen 1 and gen 2 mats come out but I believe ours only have 1 on the drivers side. and none anywhere else.

[Pablo Vasquez]

It just snaps in and out. Give it a good lift, you should be fine.

[Tsirhk]

Give it a little bit more elbow grease when pulling. I wanted those liners but its much more expensive than weather tech grrr.

[kasakato]

Which liners are those? They look like the 3D Maxpider ones I have, just with a logo. Removal is possible by holding down the carpet around the pin and pulling the liner up.

[TReyes]

Tsirhk yeah they are quite pricey but I had to get them... they look great and protects my car from my muddy construction boots.

[TReyes]

kasakato these are the OEM Mazda 3 floor liners (Mazda accessory)

[TReyes]

Quick update for anyone else who purchases these floor liners

Removal is simple - you push down on the middle button area with one hand and pry off the liner at the same time with the other hand. It will pop off when you pull with a bit of force. No need to use any tools to lift up button.