It would seem to me that the dealer charges about $180-$200 for the arm at the parts counter. If you could pay for actual labour, (assuming you could buy a minimum of an hour) you should be able to...
Type: Posts; User: Chester_Lampwick
It would seem to me that the dealer charges about $180-$200 for the arm at the parts counter. If you could pay for actual labour, (assuming you could buy a minimum of an hour) you should be able to...
D'oh! I need to pay more attention
Well you could check that they fit snug on the spark plug. If you had a wire brush you could give them a once over. ...
I don't remember him mentioning if it was a Mazdaspeed. Or even if it was a Skyactive or even what year.
No. I don't think that is a certainty. Cars run pretty clean these days. Back in the day before modern fuel injection where carbs would run rich, then yeah sure.
Don't guess. If you determine...
Why would you want to have your walnuts blasted?
So if your door switch is broken, then perhaps your interior light is on too? If you have super dark tint you wouldn't notice when walking away from the car.
Kijiji has the tires you need if you can't afford brand new.
Anyone in? I admit it's a guilty pleasure for me to watch.
Timing belt broke?
I believe the Chargeguard has two modes, either time delay after key off, or settable voltage threshold for shutoff 11.5V, 12V, 12.5V. etc. If you spent a little time with Google, you could download...
You wouldn't add a voltmeter to an accessory port.
Voltmeter:
http://www.polytechnichub.com/wp-content/uploads/2017/04/digital-voltmeter-1.jpg
or...
I think you are trying to say that the accessory port isn't switched with the ignition switch or does not have a battery saver. Also known as "always on" or "constant power".
A voltmeter is a...
I was meaning to have an alignment, but just have been too lazy to set that up. I haven't noticed any abnormal tire wear or steering issues.
If you got both sides done for $452, I'd say that is...
Strip off the paint and let it patina.
http://carphotos.cardomain.com/ride_images/3/2823/222/32055110946_large.jpg
https://www.youtube.com/watch?v=9g1efBYnyas&t=2s
14mm
Are you going to tint them redder than red?
Came in hoping the OP's question wouldn't be as vapid as the thread title.
Leaving disappointed.
I don't drive the car nearly as often as my wife. Maybe once a week.
I would say that the car is much tighter now. It was a definite improvement.
If you could supply the parts and just pay...
I would say somewhere between. The car did have a little bit of front end clunkiness. The car only has 120,000 kms on it. I don't have any particular tools or techniques for gauging ball joint wear,...
Actually, the ball joint was no problem at all. It's integrated with the control arm. The nub that goes into the spindle comes out with a couple nudges of the BFH.
The other side was easy once I...
Hi all,
Just wanted to pass on some tips I for replacing the control arms on a stock, unmodded 2010 Mazda3. The instructional videos on Youtube are a good place to start, but the ones currently...
A muffler isn't an air pollution device. It's a sound pollution device.
You should go with whistle tips, Cali style.
https://www.youtube.com/watch?v=Nnzw_i4YmKk
Wooo wooo!
So, the Maserati beside it is chopped liver? tsk tsk
Sure. I guess that's what I'm saying. I did that and it worked to get Bluetooth working again. A hard reset. I just remember having to pull a few fuses to find it, and even dropping and losing...
Sure. I guess that's what I'm saying. I did that and it worked to get Bluetooth working again. A hard reset. I just remember having to pull a few fuses to find it, and even dropping and losing...