Search:

In a perfect world, no coolant top up is necessary since it's sealed. However, hoses does leak minute amounts of coolant and you will need to top of the system. In the Mazda, I had to top it off...

https://www.wnycstudios.org/story/death-sergei-magnitsky-bill-browder/

The death of Sergei Magnitsky and how the Magnitsky act was formed.

Agreed. Cleaning them did jack squat for my vehicle. Did it the few times I changed my air filter. If it makes you feel any better to clean it, by all means.

Back to what the OP is experiencing....

Seeing that burnout, I want an LSD on my ride.

Get in touch with Jimmy at Street Performance. He did mine when I had a leak.

What I meant is if you're swapping your current transmission onto the 2.5 it may be slightly easier than a manual due to all the connections you'd have to remove (shifter cables, bleeding of clutch...

I have a manual transmission, so I'm not sure. It could even be simpler as it's all electrically controlled with an automatic.

For anyone else doing the same swap on a manual transmission, i...

I paid 650 for the engine and it was from a used car engine dealer in Brantford. If it helps with pricing yours out, mine had about 50K km on it. Came with intake manifold and throttle body (which i...

2.3 to 2.5

https://image.ibb.co/jWK1OG/20171105_181459.jpg

Ret-Ret

My engine was from a 2010 Mazda3 2.5L (non-Skyactiv)

I've been putting it off since I didn't have the garage space (single car) to take on such an ordeal. BUT I just finished the swap...

As mentioned in our messages. Try Jimmy at Street Performance. He would visit these pages once in a while, hopefully he can chime in on whether he would be willing to take it on.

Swap it for a 2010/11 2.5L from a newer Mazda3.

I am having my swapped out as we speak. Clogged cat, failed coil, oxygen sensor and the dreaded quart of oil every 400-500km did it in.

I have...

Yep, took a good 2-3 hours to change mine. Most of that time is trying to wiggle a socket into the hole where the center bolt for the intake manifold is. If I were to do it again, I'd remove the rear...

The car has been handling like it's got worn lower control arms again. Tendency to fall off line when going over minor bumps. Exaggerated turn angles during on and off ramps.

Although my last...

Can someone explain what this is for?

Favourite beer at the moment.

http://thebrewthusiast.com/v1/wp-content/uploads/2012/05/BT-Sofie.jpg

Another favourite of mine is Trappistes Rochefort 6, but I've only found this at the Bier...

Can someone photocopy or a picture one of their receipts for me? I lost mine :facepalm

Damn. I was hoping that wasn't the case with my car as I also got Moog control arms installed less than a year ago :bang

I do not know the sizing for these, but if they happen to fit, these would be on the top of my list.

http://corksport.com/mazda-billet-sway-bar-brackets.html

Rust doesn't seem to be an issue with the 07 that I have luckily. The engine is drinking oil however and has been since 2013 with a little over 100K km and she's at over 201K km. Can't even take a...

Does anyone have the timing kit that I can borrow or buy off of?

Can the AC be made to work though? That was one of the things that I've been looking the answer for.

I will doing the swap

Keep those shoelaces on Derozan!

Replaced both sides of the lower control arms with Moog parts last year and haven't had any issues.

Thinking of tackling this soon. Anyone have any advice?