Oh boy, don't know what I was thinking when I wrote my above comment, it must have been a rough morning.. lol
Flagrum_3 is definitely correct about using coolant. Just to add to this, you still...
Type: Posts; User: Polish_Eagle
Oh boy, don't know what I was thinking when I wrote my above comment, it must have been a rough morning.. lol
Flagrum_3 is definitely correct about using coolant. Just to add to this, you still...
If temperatures never reach freezing you can use just distilled water. However, if temperatures do reach freezing, you absolutely need some antifreeze to prevent damage to the block. You don't have...
Why would it matter, it's a recall, and that means the manufacturer fixed said issue. So this is a non-issue. I'd buy it.
I use the following on all my servers (it's free): https://letsencrypt.org/
Also, to make the install easier there's "certbot" that will install the cert for you and setup HTTPS.
Why doesn't this forum use SSL?
When replacing cams, you'll also need to do the valve lash adjustment. So worst case scenario, if you had to replace all 16 buckets, you might be adding a lot more in cost. Last I remember when I did...
Ooooo, do want, would be nice on my build motor with port injection. Moar powa!! :)
Is the suspension stock, if not, what is it and how many KM's on it? Also, do you have an EGR too? PM me pricing for everything.
You'll also need the wire diagrams for your car so you know which wires to look for and test.
Mazda VCM2 with their IDS software. I have a high quality clone that I've been using for a while and it definitely is a helpful unit to have.
That's a sweet garage setup you have. I always wanted a lift in my garage, I've been on the fence for a quick jack.
Enjoy, Rob will really bring the car to life! From all my tunes (Rob, Freek, & Stratified) Rob made the most power and also made the car drive the best.
Spray some soap water on the fittings and create some boost while a friend looks at the fittings. If you see it bubbling there's your problem. You could always go to the hardware store and pickup a...
Absolutely not the same. Do not waste your time and money on attempting it.
I have a Gen 2, but the bolt won't come out on the one side if you pull straight out. What I did was unbolt it, and when you try to remove it you need to angle the control arm so the bolt is angled...
Oh damn, so it's quite impressive your turbo was still hitting 23 PSI. Nice find!
Take the wheel off, remove the two control arm bolts, swap arms, now reinstall. That's all I did and the total install time was about 15 minutes a wheel.
I've had Rob tune my car and he's awesome, so I highly doubt it's tune related. I'd definitely do a smoke test to see if there is a small boost leak. If all is good I'd add more preload and let Rob...
Is your tune boost, load or hybrid based?
I've put 200k on my OEM timing chain and it was still good. Usually as it wears you'll hear the chain slap against the guard in the valve cover.
I've been using the T6 0W40 for quite some time. I haven't noticed any issues with it.
I personally hate the OTS maps, when I use to have an AP I had so many issues with boost cut during the winter. As for tuning, I highly recommend Rob Finkle from Hypnotic Tuning...
Until the JBR TMM fails and your transmission drops...
That's probably the best decision you can make!
I have a Cobb rear mount and it sounds almost as quiet as stock and it also feels pretty solid in the car. I'd recommend avoiding JBR mounts as he has had quite a few fail (documented on MSF and in...