Search:

Just experienced this.. haha.. problem was with the buckle. Pressed the red button a couple times and the light went off.. too bad.. could've just told people it was a ghost sitting in the passenger...

Make a myth out of it. You were doing 90 in a 60 because you were being chased by the husband of a woman that you just had intercourse with. He was out for blood and you wanted none of it so you ran...

You need a capacitor. Without it, it'll flicker.

I have 4 speakers that I am thinking of making a box for.

2 x 6.5" and 2 x 5.25"

I'm curious if anyone knows what the female crimp connectors are? I checked the speakers but the male crimps...

There were 2 problems.

1) The soldered wires that connect to the lighting harness disconnected. I went with a different method this time so I hope it holds. I decided to crimp them instead.

2)...

I've replaced the HID wiring harness 3x already and again, I'm having issues with the HIDs.. GRR..

I checked to see if the power was still connected to the battery terminal; Check.
Checked the...

I ripped off the rear heat shield near the gas tank because it was barely hanging on and hitting the exhaust. Do I need to replace it or would it be fine without it? If I do need to replace it, how...

http://s3.postimg.org/c3726l9c2/20151209_125527.jpg

On my end it goes full screen. No issues

Click on the photo... lol...

This is what it looks like on the car. I used the old weld to center the tailpipe on the muffler. I might bend the upper bracket by 45° so it sits flush with the bushing. Well see after the test...

Passenger engine mount.. put a jack under your engine, lift the engine slightly, remove the bolts and pull it out and take a look at it.. if the rubber is separated, that's your problem.

It stops...

1) Passenger Engine Mount
2) Spark Plugs/Misfire
3) MAF Sensor (Clean It)

Also, when unhooking the battery, you need to turn on the car and let it idle for 5-10 minutes.. touch nothing.. let the...

Check your muffler hangers.. sounds like one of them may be broken.. sounds stupid but I have the same type of rumbling noise and that's my problem hahah.. in the process of fixing the hanger...

There's been a rise in the transmission of STD's ever since Tinder came to be.. coincidence?

A month or so ago, I had 2 exhaust hangers near the rear of my Gen1 snap off.. because of the rust, lots of places want me to replace the exhaust before welding a hanger on.. f* that..

I had a...

I usually get Pennzoil 0W-20 or 5W-20. Depends which one is in stock at the Crappy Tire I visit. I also replace the synthetic Fram filter with each oil change.. total cost is around $70. Plus 20-30...

Mine is a 2006 Gen1 w/ 190,000km..

I didn't spend much on repairs either until the past 2 years.. that's when things started to go wrong all over the car..

I just changed the passenger motor...

I replaced the rear sway bar bushings with the OEM rubber ones and the rear clunk is gone.. so the poly bushings didn't work for me.

I had a mechanic check the front suspension and he determined...

Vehicle maintenance has definitely not been neglected.. it's just Murphy's law.. when one thing goes wrong, everything goes wrong. Just frustrated that everything seems to be breaking all at once.....

Turns out to be the ball joint.. had a second mechanic look at it.. not much play in it but he said the sound is definitive. He said as I brake, the vibration/up and down motion, causes the ball...

Since August.. I've had to replace the rotors (skipped out on the pads as they still had a lot of life left on them but now it squeals.. FML).. then the back 2 muffler hangers broke.. I haven't...

Handbrake isn't seized.

Not the rotor.. I can hear the chatter even when the brakes aren't applied.. it's faint but noticable.

I have replaced the struts, endlinks, CV shaft already.. guessing...

I am hearing a chattering noise coming from what I'm assuming is the brakes.

I can hear it sometimes just driving along with slight changes in elevation and when I hit the brakes hard.

I'm not...

It's going to get real ugly come the next winter.. not sure if I want to drop >$1000 to fix it or if I should just get a new car.. CX-5 is my next pick.. big fan of the interior in the 2016 GT model.