i needed an air hammer to replace my bushings/bearings and struts last year.
i ended up getting this, Ingersol rand 118max, i would highly recommend, made work a breeze.
Type: Posts; User: roachkillah
i needed an air hammer to replace my bushings/bearings and struts last year.
i ended up getting this, Ingersol rand 118max, i would highly recommend, made work a breeze.
Ktown
changed oil, swapped over to winters
noticed spring is broken close to the the base of the strut, and have slight lower balljoint play
thanks morganc
but i am super strong thus i dont know my own strength - kidding -
ima keep on googling this
Hi,
I am replacing the driver side no. 04 mount, i have googled this, but i keep on coming up with 2 different torque specs
does any one the the torque specs for a 2008 mazda 3
thanks
i will look at this as well
been meaning to learn to play guitar
cant find local
unless u might want to try a junkyard
i bought one of ebay for $70 a few years, ago, the bearing is garbage in it
i can hear it whining at times
but at least the AC work
jesus
that is insane amounts of HP.
amazing!
I used Meguiars clay bar and Zaino Z-CS
amazing build!
great looking car!
will start following on IG
changed driver side engine mount, washed/clay bar/sealed my paint
maybe NSFW
https://www.youtube.com/watch?v=Q5GisodObN4
with my old car i opened the headlight after using morimoto hid kit for several years, right before the car went to the junkyard
the bowl looked just like what Hyperion posted.
no doubt it worked...
i had it for 3 weeks, i kept at it for about 15mins daily and could never get that razor sharp edge i was hoping for
sadly i returned it.
i couldn't get over that learning hump.
Hyperion wow, that light outputs is incredible!!
i had almost an identical problem.
pedal got soft suddenly, after diagnoses we decided to replace the master cylinder.
it was bench bleed, once installed we bleed the lines.
it seemed better, but...
i removed and serviced my caliper bushings using needle nose pliers and silicon spray
you have to go slow, they will come out. Once out, i noticed there was salt build up or some sort of hardened...
https://www.youtube.com/watch?v=LNzvicd319c
thanks man, i knew it
Damn, the body shop that changed my radiator and condenser from an accident i had, installed this backwards ( yet another one of the many issues, i have found so far )
Is it...
Hello,
Should the radiator fan be blowing air out or pulling air in?
My fan blows air out, i figured this is incorrect.
Thanks.
thanks for the replies
i have the rails already, i just need the carriers.
i will check rack attack and amazon.
Hello,
Can anyone recommend a good place to purchase a roof bike carrier.
Also, what brand would you recommend?
Thanks,
Santiago N.
yes i replaced the coil,
as for the belt no need to cut, remove the four screws at the bottom and tilt the compressor slightly upward at an angle, it comes right off. put it back in the same way....
if you couldn't hear your ac clutch engage, it could be your ac clutch, you're low on freon or your compressor
check your ac clutch, go under your car there is a wire that comes from the...