How do i remove the back bumper on a 2011 mazda 3 hatchback?
My rear bumper is falling apart.. it hasn't been rear ended or anything. The driver's side of the bumper moves up and down and squeaks as I drive along. There is a clip with a rubber seal under the wheel well and the rubber seal is worn out and ripped. I need to remove the entire bumper to check for broken clips and purchase the worn out clips.
Re: How do i remove the back bumper on a 2011 mazda 3 hatchback?
Remove all exterior clips attached to rear bumper. You have to remove your taillights to access some screws holding down your bumper. I'm not sure if there are any clips/screws in the trunk holding it down.
Good luck!
Re: How do i remove the back bumper on a 2011 mazda 3 hatchback?
thanks =) , im going to give it a try when its warmer.Originally Posted by loosecannon
Posting Permissions
Reply With Quote