I know rpf1 17x9 +45 will work on a genwon speed... with fender roll (and maybe pull). To be safe I was told I may need 10mm spacers to clear the strut. Just to add to the discussion and clarify somethings.... i'll need extended studs, and new lug nuts when I run these wheels?
Last edited by Prezi; 03-13-2014 at 04:36 PM.
Mspeed Tuned... .Prezi
Think most can get away with 5mm spacers on the front, which wouldn't require extended studs. Most likely you will need a tuner style lug.
@Thrizzl3.
0.000212524463 gigawatts
I run 10mm just to be safe but extended studs are needed
alright, thanks guys!
would i need extended studs to run a 7 or 8 mm spacer? anyone know where to get some? everywhere ive chcked seems to be 100 $ + range
400WHP Club!
Gingerbuilt-Self Tuned-Built Short Block yada yada yada-Enkie RPF1 17x9 +45 wrapped with 245/40 PSS
Check out my build thread! http://www.torontomazda3.ca/forum/sh...s-Build-Thread
Can anyone measure the outer diameter of their spline lugs for me, please?
@marcodude04
Good quality spacers are a must... eBay is good yes however make sure you are getting what you expect and not a cheap knock off....
I found these RMX wheel spacers that 'should' work with mz3 because they are the same specs... but are for the Hyundai genesis . They are about $100 a pair for 15mm to 38mm and seem like a good make:
http://uniqperformance.ca/products-p...enesis-wheels/
They are also located in the 416
Last edited by Lmmorden; 04-27-2014 at 09:44 PM.
Thank you for the tag I completely forgot about this post ; I'm Gonna eventually run a 5 mm spacer but probelm is I have closed ended lugs now? But for a small spacer I should be fine with that right?
Also for the torque and such on the lugs, I just researched this the other day as I changed out my rims and needed tuner lugs. Book shows 66-86 fl/lbs of torque. I used 80lbs since it is easy to remember.
2008.5 Mazdaspeed 3, CWP
Forged internals + GTX2871r
// Build thread // Instagram: @sleepy.ms3
I ordered a set of Enkei Raijin, they come in today (18x8, 45mm offset).. Am I gonna need new lugs or anything special? I'm no enthusiast of rims whatsoever
I believe you can use oem, however they are very large and your wheel might be scratched when you try and take them off. I'd suggest aftermarket tuner lugs
Modifications? I've forgotten more than I remember. Click here for the list.
Any specifics? I usually order everything online. Will I need spacers