Does anyone know of any good adjustable endlinks?
My OEM ones are starting to come apart and its time for new ones?
Does anyone know of any good adjustable endlinks?
My OEM ones are starting to come apart and its time for new ones?
Tri-point ones?
Current: 2016 Lexus GS-F, 2017 Honda CRV Touring
Past: 2015 Scion FRS 6MT, 2010 M3 E90 6MT, 2013 Scion FRS 6MT, 2005 Mazda 3 GT Hatch.
if you're not going to 1) track your car, or 2) use aftermarket adjustable end links to dial out pre-load, or 3) run a larger rear bar..then just go with OEM.
if you do decide on Tri-Point rear endlinks, note that it doesn't have rubber bushings so you WILL hear clunking in the rear at times.
my driver side one is making a clanking noise , so i bought a pair of oem endlinks off ebay 40 plus free shipping
Is OEM good enough for Rear Sway bar (HotchKiss)?
Anybody try these
http://www.powergridinc.com/swaybar.asp
Or These
http://www.whiteline.com.au/do_segue...+1%2F04-9%2F09
Regards
Shawn
Anybody put MazdaSpeed Rear links on their Mazda3 ?
wait jason..u need rears? i thought the noise was coming from the front...?
You can us OEM Mazdaspeed3 links. They will fit the HotchKis, but measure the hole in your bar to make sure.
I just bought a set from MOT. They are 12M1.25 stud (beefer than MZ3) for the bar and 10M.1.5 for the control arm connection. Mazda ones do not come with the Nuts. . So you have to order separately.
Or you can order Moog ones for Mazdaspeed3. They are about 10$ cheaper than Mazda and the have a bronze ball cup and have grease fittings. PN# K750069
I hope I don't regret getting the Mazda ones.