I'm not sure if I will explain ts right but I'm going to try anyway.
I'm this car a little odd to drive hard around the corners then my 6 was. I find the Speed3 chassis is harding to maintian chassis balance with the throttle while in a corner. Here's what I mean, on my 6 i would go into a corner with about half throttle to maintain speed and use the throttle to fine tune the line. The Speed3 doesn't seem to have the same pedal. I figured there was nothing I could do about it until yesterday. After coming home from the dyno I've reading through every bit of literature on ATR. I also came across the throttle tables and was a little confused.
Neutral APP translation table is the only one that makes sense. 30% is 30% but the other tables don't mame sense to me. In the other tables it says i have to be at 50% pedal position to be commanding the throttle plate at 30%. At 70% the throttle is commanded to open 50%. This doesn't make to much sense to me.
So I just adjust all values in all the tables to match the neutral table. Will this give me the linear throttle i'm looking for.