Front splitter/front flat underpanel

[a_ahmed]

Has anyone built one?

The plastic cover in the front broke and I have it off right now, but it made me wonder if a front splitter flat under panel has been made by anyone?

2006 mazda 3

[Sonic31]

If you are talking about that annoying undertray the only upgrade/replacement I know of is from corksport

[a_ahmed]

Ya I'm talking about that garbage oem undertray, that corksport one is not CAI friendly and lol 250 bux.

However this is what I'm talking about:

[Sonic31]

Ah, you might be looking at having to customize something then.

Never seen anything like that available for the 3.

[leecheefoto]

I'd rather buy from Corksport. I'm telling you now a splitter held by screws and 2 rods upfront and nothing to hold in the back will be too heavy unless you do some welding going on. By the end of the project you'd have spent more than 300 beans. Message Kiyomi since he's making his own and is in the process of almost completing it.

I've had Jon Nextmod's front splitter made from CF and a couple of ARP rods but they don't replace the undertray.

If you're limited because of the CAI then make short ram (please don't have the debate over difference of CAI and SRI performance).



btw, doing an oil change will be more time consuming if you don't have any cut outs under the tray.