Results 1 to 16 of 16

Thread: SilentJay's Log

  1. #1
    Sr Member SilentJay's Avatar
    Join Date
    Apr 2007
    Posts
    5,329
    Thanks
    2
    Thanked 68 Times in 55 Posts
    Mentioned
    45 Post(s)
    Tagged
    0 Thread(s)

    Default SilentJay's Log

    I know the log is kind of long, but I wasn't quite sure what to cut out.

    4th gear pull, traction ctrl off, didn't quite make it to redline though. What do you guys make of this, other than I should probably trim it?


    I'm running: short ram intake, tip, internals, forge bpv, cpe tmic, OTS stage 1 @ 91 octane


    Reference: deleted
    Last edited by S.F.W.; 11-28-2013 at 01:45 PM. Reason: user request to have csv deleted

  2. #2

    Join Date
    Mar 2009
    Location
    Kitchener
    Posts
    5,742
    Thanks
    213
    Thanked 1,156 Times in 643 Posts
    Mentioned
    295 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Where's the pull? Throttle never goes above 30% and wastegate duty cycle is at 0%? and boost barely touches 10psi?
    - 2016 Lexus NX200t F Sport -
    - 2010 Mazdaspeed 3 Black Mica - SOLD -

  3. #3
    Sr Member SilentJay's Avatar
    Join Date
    Apr 2007
    Posts
    5,329
    Thanks
    2
    Thanked 68 Times in 55 Posts
    Mentioned
    45 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Hmm... I might've put up the wrong one then... Lemmie check.

  4. #4
    Member
    Join Date
    May 2012
    Posts
    1,405
    Thanks
    28
    Thanked 160 Times in 111 Posts
    Mentioned
    53 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Lmao... ohh Jay, you need to go Wide Open Throttle (WOT) by flooring the accelerator and grabbing the wheel the keep it straight as can be.

    Steps (some you have done but I writing them all out anyways):
    1. Make sure you have enough space on a straight safe place of road
    2. Traction control off (hold down 10 seconds, light will stay and not be able to be turned off)
    3. Start logging from 2500 rpm in 4th
    4. Floor it to 5500-6000 rpm (ideally redline)
    5. Stop logging

    Angling the wheel on a gentle bend will cause the SWAS(Steering Wheel Angle Sensor) to activate which will give you rich AFR and reduced timing. So try to avoid that if you can because your log won't show the real values we are looking for. @SilentJay

  5. #5

    Join Date
    Mar 2009
    Location
    Kitchener
    Posts
    5,742
    Thanks
    213
    Thanked 1,156 Times in 643 Posts
    Mentioned
    295 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Quote Originally Posted by SilentJay View Post
    Hmm... I might've put up the wrong one then... Lemmie check.
    Haha ok


    And pwndunmore - 4th gear logs aren't really necessary with a stage 1 OTS map...he should have no problem with traction in 3rd gear and it keeps the speed a tad more legal.

    Logging is not recommended on public roads, be careful

  6. #6
    Sr Member optiklenz13's Avatar
    Join Date
    Jun 2009
    Ride
    Jeep Wrangler
    Posts
    5,326
    Thanks
    381
    Thanked 589 Times in 307 Posts
    Mentioned
    129 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Pm @Fack_Dude , he knows a place to do logs.. @SilentJay

    Log phail?


    Instagram : optiklenz13 / focalpointconcepts

    www.optiklenz13.com
    FPC10

  7. #7
    Member
    Join Date
    May 2012
    Posts
    1,405
    Thanks
    28
    Thanked 160 Times in 111 Posts
    Mentioned
    53 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    4th gear logs are the best way to tell how the engine is running because the engine is under proper load, 3rd gears logs "work" though.

    And I do all my logging in Mexico with my submarine radar fully activated lol

    As Someguy said be careful and don't log/post vehicle speed. Not needed and attracts the wrong attention.

  8. #8
    Moderator Mr Wilson's Avatar
    Join Date
    Jan 2010
    Location
    Toronto
    Posts
    4,619
    Thanks
    1,328
    Thanked 700 Times in 381 Posts
    Mentioned
    227 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    fack_ dude only leaves logs....
    0.000212524463 gigawatts

  9. #9
    Member fywdyl's Avatar
    Join Date
    Jun 2010
    Posts
    1,631
    Thanks
    88
    Thanked 105 Times in 64 Posts
    Mentioned
    40 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Quote Originally Posted by pwdunmore View Post
    4th gear logs are the best way to tell how the engine is running because the engine is under proper load, 3rd gears logs "work" though.

    And I do all my logging in Mexico with my submarine radar fully activated lol

    As Someguy said be careful and don't log/post vehicle speed. Not needed and attracts the wrong attention.
    Speed's not an issue because we ALWAYS do our logs on a dyno, car's not actually going that fast...
    Quote Originally Posted by Peter View Post
    There's room it's just really tight I had the same issue play with it a little and it will work
    Quote Originally Posted by horto View Post
    that's what she said...

  10. #10
    Banned
    Join Date
    Apr 2010
    Location
    Projects
    Ride
    another mazda
    Posts
    1,976
    Thanks
    67
    Thanked 261 Times in 121 Posts
    Mentioned
    51 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Hey silent jay. This will be the best advice I will ever give you about logging. You have to have the balls to do it. I have done over 600 logs in the past four years and I can tell you one thing I didn't care if my car blew up because I would by a new car the next day and their people on this forum who know who I am. Enough being said. The best thing you can do is get a tune and do it on the dyno and call it the day. However, if you feel that you can do these logs and have the money to spend when you grenade the engine. Send me a pm and I will show you how it's done.
    Last edited by Fack_Dude; 11-28-2013 at 01:44 PM.

  11. #11
    Sr Member optiklenz13's Avatar
    Join Date
    Jun 2009
    Ride
    Jeep Wrangler
    Posts
    5,326
    Thanks
    381
    Thanked 589 Times in 307 Posts
    Mentioned
    129 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Derek for President..

  12. #12
    Member Stathakos's Avatar
    Join Date
    May 2013
    Location
    Scarlem, Hoontario
    Ride
    2007 VW Rabbit 5MT
    Posts
    1,117
    Thanks
    315
    Thanked 134 Times in 72 Posts
    Mentioned
    86 Post(s)
    Tagged
    1 Thread(s)

    Default Re: SilentJay's Log

    Quote Originally Posted by optiklenz13 View Post
    Derek for President..
    +1

  13. #13
    Sr Member SilentJay's Avatar
    Join Date
    Apr 2007
    Posts
    5,329
    Thanks
    2
    Thanked 68 Times in 55 Posts
    Mentioned
    45 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Likely not 100% complete log, had to steer a tiny bit in each instance, 2 separate pulls, and probably has some filler columns that need to be removed... Was just hoping this might provide me with a little insight.

    Log 2.xls

    Log 1.xls
    Last edited by SilentJay; 01-30-2014 at 10:26 PM.

  14. #14
    Sr Member SilentJay's Avatar
    Join Date
    Apr 2007
    Posts
    5,329
    Thanks
    2
    Thanked 68 Times in 55 Posts
    Mentioned
    45 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Hopefully, 2 slightly better quality pulls

    3.xls

    4.xls


    To note, I'm running the OTS stratified stage 1 map now

  15. #15
    Member fywdyl's Avatar
    Join Date
    Jun 2010
    Posts
    1,631
    Thanks
    88
    Thanked 105 Times in 64 Posts
    Mentioned
    40 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    Jay, I would start the pull/logging at a lower RPM, say 2500, but most of us start it at 2000.

    Also... if you can go to at least 6000 RPM at least you have a better idea of the upper end.

    I would say nothing out of the ordinary, it's a very conservative map, so tons of room to grow.

    EDIT: Not sure which version AP you have, but there's usually a 1 sec lag between pressing the log button and the actual recording of the log. So take that into account when you start a log.

  16. #16
    Sponsor - Mspeed Tuning & Diagnostics
    MajesticBlueNTO's Avatar
    Join Date
    May 2004
    Posts
    3,291
    Thanks
    77
    Thanked 239 Times in 111 Posts
    Mentioned
    49 Post(s)
    Tagged
    0 Thread(s)

    Default Re: SilentJay's Log

    i've posted this before in other threads....just start logging when you start driving (or after you start your car). Do your pulls without worrying about when to press the button. Then, when you're done driving (prior to shutting off the car), stop logging.

    Once at a pc/laptop/tablet/whatever, go into a csv editor and then chop the big csv into the chunks that have the WOT content. The AP v2 can hold about 10 hours worth of logs.

Similar Threads

  1. SilentJay's SilentSpeed
    By SilentJay in forum Member Rides
    Replies: 10
    Last Post: 10-01-2013, 11:39 PM
  2. SilentJay's Car
    By SilentJay in forum Member Rides
    Replies: 17
    Last Post: 05-11-2011, 10:50 AM
  3. Happy Birthday SilentJay!!
    By She_Prime in forum General Lounge
    Replies: 11
    Last Post: 05-06-2009, 08:07 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •