Wiring Angel Eyes problem !!

[Ycharb]

Hi, this is my first post I think on this forum. Hope I can find some help.

I have bought a set of headlights with chrome finish inside and integrated angel eyes (only around low beam dome).

Out of the headlight comes a black and a red wire.

I also have the standard wiring harness that comes with most angel eyes kits.
So I have plugged the following from the kit:

Screwed the relay to the car ground spot + connected the main black wire to the ground spot too.

Connected the main red wire from the relay directly to the battery terminal.

Now I have 2 sets of 1 red, 1 black and 1 red/white wire.

I have connected the the red and black to the Inverters and then connected the same from the inverters to the angel eye wires.

The red/white wire is connected into the fusebox in the empty slot. I have T-tapped the other red/white wire to that one too so it gets signal from the fusebox.

Now I haven't seen anything from the halos. But only once, when I disconnected the red wire from the battery terminal and reconnected it on the other bolt (from the same terminal).

The halos went flashing only once, then nothing.

I have no idea what I'm doing wrong, I would like some help, those of you who did the angel eyes modification!

Thanks

[skunk2]

got pics?
bypass the relay for now....just test the inverter or ballast that came with it, make sure it works. connect the wires from the angel eye to the ballast then ballast staight to battery. amke sure you get the polarity right.
when you see it work then get your relay......you might have just wired the relay wrong.
what kind of relay did it come with? 4 or 5 prong?

[SpelingChampian]

Here is what my wiring set up looks like...

http://i391.photobucket.com/albums/oo359/SpelingChampian/TM3/angeleyewiring.jpg

and my fuse box...

http://i391.photobucket.com/albums/oo359/SpelingChampian/TM3/angeleyewiring2.jpg

If you have any questions (or anyone for that matter) just add me at spelingchampian (at) gmail (dot) com