View Full Version : Polk Audio db212-2 w/ alpine MRP-M350
Greg_di
01-26-2009, 08:19 PM
Hello all,
I am thinking off getting this setup (The Polks are on sale for $250, $250 off) and looking to get an amp for them. I can get an Alpine MRP-M350 for $80.
I am not very knowledgeable about car audio but will this amp be good enough for those subs or should I look at something else? Any Suggestions?
Greg_di
01-26-2009, 08:21 PM
forgot to mention***
For the time being I will be using stock deck/speakers until the summer if that matters. In the summer I will be looking into new deck and replacing all 4 speakers in the car.
Whosit
01-26-2009, 08:25 PM
That box is 720 Watts RMS at 2 ohms but the amp is only 350 at 2 ohms. You might want to consider an amp that gives you some more power. Other wise you may find yourself cranking the gains and causing damage to the subs. Remeber you can blows subs by under powering as well as over powering....
Greg_di
01-26-2009, 08:38 PM
any suggestions of good amps suitable for those subs? (new to car audio)
Whosit
01-26-2009, 08:46 PM
What are you looking to spend on an amp?
VetalM3
01-26-2009, 09:49 PM
http://www.onlinecarstereo.com/CarAudio/ProductDetail.aspx?ProductID=19580
Hifonics BXi1208D: RMS Power @ 2-Ohm: 900 W x 1
Whosit
01-26-2009, 09:50 PM
If you do go with that amp just make sure your gains are set properly. 900wrms into a box rated for 720wrms will damage it if not set up properly.
Greg_di
01-27-2009, 12:49 AM
Hey Whosit thanks for that pm!
Whosit
01-27-2009, 08:28 AM
No problem!
Powered by vBulletin® Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.