2010 MS3 fog light

[gar_lei]

Hello

I'm trying to change the bulb of my fogs to yellow
the driver side was easy but the passenger side when I try to go from the mud guard, all i c it's containers of windshield washer and other stuff....
does that mean I have to remove bumper or there's other ways like from splash underneath...


Thanks in advance

[greardon]

Should be the same on both sides, did my speed ones and it took longer to remove the screws holding the cover in place than it did to replace the bulbs

[gar_lei]

i opened it up and all i c is plastic containers

[miako]

you have to use your left hand go underneath the windshield washer container it's a bit tough but it's doable, just have to look through the fog lense to get the right location..... i did mine last year...

[chan7]

Have to tried removing the screws from the splash guard and wheel well on that particular side? I recall removing about 3 screws from the wheel well and 2-3 from the splashguard and just bend the plastic back to access the fog. Not sure how different it could be in comparison to a regular 3 and the speed3.

[funeh]

I have a 2010 Mazda 3 GTE wheres did you get your fog light bulbs. Were you successful in changing them.. Let me know thanks.

[win-]

Take out the 3 8mm (phillips) screws under the bumper (right and left side), bend the panel down and reach up from underneath.
Just installed HID fogs today, but it was easier for me because I had it up on my hoist. Previously I just had yellow replacement bulbs in there and I pretty much went in the same way. On the passenger side you just need to stick your hand up underneath the washer fluid resevoir.