View Full Version : Tech Question - CEL #P2187
padraigmacgearailt
11-04-2011, 02:19 PM
:(Hello, I'm new to the Forum and have a question. I have a 2006 sedan and the engine fault stays on: fault # P2187 does anyone know what this is?
Hope I'm in the correct section.............Padraig
Mr Wilson
11-04-2011, 02:24 PM
system too lean at idle
rzapata
11-04-2011, 02:29 PM
I found this over the net and it shows a table of what might cause this.. It says "Fuel system too lean at idle"
http://ww2.justanswer.com/uploads/tracker40/2010-01-16_213051_1.gif
Possibly the o2 sensors... Did you install any intake or what not at the moment?
padraigmacgearailt
11-04-2011, 02:50 PM
I haven't made any changes or additions. The light came on once befor and it the gas cap. I'v only had the car about 4 months
rzapata
11-04-2011, 03:07 PM
If I remember correctly, I had the same code when I used seafoam on my old sedan. It threw a CEL with the same description because apparently, that's what happens when you use seafoam. I had it cleared and it never came back since then. Don't know what happened to it now though.. :)
But yeah, check out the list of stuff on that picture that I posted, maybe you'd find something useful there. I suggest have a look at the ones that are easily accessible first, do a quick check and go from there..
cwp_sedan
11-04-2011, 03:11 PM
Do you have any problems starting the car after filling it up with gas?
Default User
11-04-2011, 04:35 PM
wasnt there a Gas cap recall a lilttle while ago?
Cosmo77
11-12-2011, 02:01 AM
Oh oh oh oh oh pick me....I have a good idea!
rzapata's post has the answer in it!
gonzo25
11-12-2011, 10:44 AM
I think that it is a purge valve or if you have an intake the maf wires being pulled loose. Would bet money on it.
padraigmacgearailt
12-12-2011, 05:35 PM
Well I finally had to take it to the Mazda dealer; It was the Purge Solenoid valve Malfunctioning. Which had to be replaced.
Total cost: Parts, labor, including diagnostic and taxes.......$368.
Thanks again for the feed-back; however I'v realized without the tech training and a computer program/equipment, I would never have found it!!
I love the old cars; none of this computerized crap.............
Padraig Mac
cwp_sedan
12-12-2011, 05:43 PM
WHAAAAAAAAAAAAAAAT!?
$368!!? That's CRAZY!
TheMAN
12-12-2011, 10:30 PM
it only takes 20 minutes to fix it!
http://www.protegefaq.net/tsb/01-025-05.html
cwp_sedan
12-12-2011, 10:32 PM
it only takes 15 minutes to fix it!
If that!
Part costs about $130 with a local discount. I guess the install and diagnostic fees killed it.
greaves82
12-12-2011, 10:43 PM
thats an insane amount
Powered by vBulletin® Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.