PDA

View Full Version : Foglight help


BlackIce
03-28-2012, 02:56 PM
So right now I am changing my deadlights and my fog. having and issue with my fogs right now. Im doing the driver side so space is limited. I managed to unplug the bulb but i still can't get the bulb out of the housing. i tried to twist and pull down and everything, how do I get it out?
Thrizzl3
03-28-2012, 03:02 PM
Just turn counter clockwise and pull.
BlackIce
03-28-2012, 03:09 PM
wow that was stupid easy. lol thanks a lot
BlackIce
03-28-2012, 04:27 PM
Sorry for double post. I noticed that my passenger side fog light is a bit higher then my driver side one. Is there any way to adjust the height of it?
mazdaskit
03-28-2012, 04:29 PM
Sorry for double post. I noticed that my passenger side fog light is a bit higher then my driver side one. Is there any way to adjust the height of it?
either the top or bottom there should be a screw with a spring thats the adjuster for it
Thrizzl3
03-28-2012, 04:37 PM
Unless you didn't put he bulb in right. Make sure that all 3 notches are lined up
BlackIce
03-28-2012, 05:32 PM
Unless you didn't put he bulb in right. Make sure that all 3 notches are lined up

I shook the bulb after i installed it to see if its in properly. It slid in without any effort so I assume it went in properly. I'll check again tomorrow. It's not a big difference but noticeable up against a wall.

And I didn't see any screws with a spring on it when I installed it.

I wanna see if I can do it on my own before I take it into a shop to align it for me. How much would it cost to align everything?