Bumper for Mazda 3 2010

[hafhoofi]

Hi
can any one tell me how can i open the front bumper for Mazda 3 2010

[ptgrad2012]

you have to open your hood, and there're few rubber screws at the front (big black plastic ones), take them out. and then at the front of the wheel wells, there are few screws too, take them off, and i tink the bumper should become loose.

That's the general idea.

[hafhoofi]

thank you for your answer
don't need to open the hid light???? and is there any screws in the bottom of the bumper???

[Kiyomi]

thank you for your answer
don't need to open the hid light???? and is there any screws in the bottom of the bumper???

if you got fog lights they will be attached. pretty sure screws underneath need to be taken off. cant remember atm.

[leecheefoto]

if you got fog lights they will be attached. pretty sure screws underneath need to be taken off. cant remember atm.

You can remove the bumper but the fogs will be attached. Remove the bumper and move it back gently and then disconnect the fog harness. Remember there's screws at bottom you can use 8mm socket to remove them
one on each side of the fender
4 push pin fenders
About 5 push pin on top
2 Phillips on top

Pull the fenders on the side out with force

[loosecannon]

You can remove the bumper but the fogs will be attached. Remove the bumper and move it back gently and then disconnect the fog harness. Remember there's screws at bottom you can use 8mm socket to remove them
one on each side of the fender
4 push pin fenders
About 5 push pin on top
2 Phillips on top

Pull the fenders on the side out with force

It's actually 3 push pin clips on each side of the fender plus 1 8mm nut on each side.

Don't forget the SEVEN 8mm nuts at the bottom of the bumper + 2 push pin clips.

[Hyperion]

Woah there guys, don't try and be more right lol.

[loosecannon]

Woah there guys, don't try and be more right lol.

And you just want to be left, right?