Remote start installed - Trips the factory alarm

[js593]

Any idea's on this?

I had a very knowledgeable guy look at this, and he took care of my install. Im going back to see him tomorrow to check it out. He said that the command start is hooked up to the data line, and needs to be switched to the Analog line.

Does this make sense?

If i start the car right away with the command start, its fine. But if i wait say 30 mins... it trips the factory alarm and i need to disable it with the factory keyfob.

Any input would be great.

This is the model used;

http://dsecanada.com/products-produits/modules/

Model # 503.

I trust the guy that put it in, but just in case, im hoping someone can chime in to see what may have gone wrong.

Thanks!

[Tozer]

Why are you leaving it running for that long/why isn't there a cutoff point?
Or am i reading it wrong..

[js593]

Reading it wrong.

If the vehicle is started right after its "prepped" for command start, its fine.

If i wait 30 minutes before using the command start, it trips the alarm.

[js593]

Reading it wrong.

If the vehicle is started right after its "prepped" for command start, its fine.

If i wait 30 minutes before using the command start, it trips the alarm.

Issue was fixed with the PAC module. If you are having this issue, you have to tie the disarm wire right into the hardline and not the data module with the BCM.