lol just kidding justin i hope u wont need it for winter![]()
lol just kidding justin i hope u wont need it for winter![]()
Does the tow hook move around when your driving?
Have you tried adjusting it so it's horizontal? Just a thought as that's how I was going to have it when I was looking at it before.
resident "Bouncer"; all-around nice guy...
Checks out.
It doesn't look bad the way it is; just more so of a suggestion![]()
Looks awesome buddy, glad you like it.
so yoooouuuuuu're the one that got to it.
Looks dope, man.
Tick.....Tock.....Tick.....Tock.....where are you, spring?
Waiting to install:
Vibrant Header
Tripoint RSB + Endlinks
Front Lip
Rear Flares
Rally Armor Mudflaps
Red G2 Caliper Paint
![]()
We're only in the first day of winter.
Can't wait to see all those things on your car, bro.
2004 Mazda3 Sport GT|Winning Blue| OG 2.3L @ 545,000 km & counting
Your car is going to look, sound, and handle absolutely ridiculous!
I have a little pile like that to lol......Front lip, reay sway, subs, fog light bulbs...its going to get bigger though lol
where's the turbo kit? lol
Your car is going to look and sound amazing! Can't wait til spring!
This a really nice shot of your car:
I can't wait to see it with some body parts added!
Good job, mista!
Mazda ... gone zoom zoom!2012 Tacoma TRD Sport DCLB 'Lifted'/ 2008 Ford Escape Limited
P.S. Due to recent budget cuts and the rising cost of electricity, gas and oil, as well as current market conditions, 'The Light at the End of the Tunnel' has been turned off.
Thanks everybody!
I've spent a lot of time and money collecting all these parts and i'm so excited to see and hear the payoff.
Question for those with rally armors and rear flares, was there any difficulties with installing the mudflaps while the flares were installed? (Mr. dilla i'm looking your way)
I don't think you will have any trouble. I'm not 100% sure though. The one mounting point underneath may be an issue for you. I would just masking tape a flare to the car and hold up a mudflap to see how it will be.
The fronts went on like a breeze, but I ditched the cheapo screws/plastic washers that came with the kit and bought black plastic push rivets at NAPA. For the rears I had to use stand-offs (thick rubber washers) between the inside brackets and the flaps. I zip cut the lower 10mm body screws that held the inside wheel well to the where the brackets attached to the body panel and replaced them with 10mm SS bolts and nuts. I'll have some pics up in the spring (maybe sooner) when I take the car out of storage or go check on it in the next week or two.
... on another note, you can always buy the side sill extensions that your dreaming about, and to avoid more clutter in your room, temporarily install them on your lower bed rails. They won't be in your way and you can sleep zoom-zoom 'til spring!
Pleasant dreams!
Past:
2003 Protege5
2007 Mazda3 GT
2002 E46 ///M
2010 Mazdaspeed3
2003 Honda S2000
Current:
2005 S2000
at least install the header and rsb first![]()
Current: 2016 Lexus GS-F, 2017 Honda CRV Touring
Past: 2015 Scion FRS 6MT, 2010 M3 E90 6MT, 2013 Scion FRS 6MT, 2005 Mazda 3 GT Hatch.